Home

Taig Micro Mill DRO X-Axis Scale

Taig Micro Mill  Taig Micro Mill DRO & Y Z Axes Scales.  Taig CNC Mill DRO  Taig Micro Mill Tachometer & SFM

RF-25 Mill  RF-25 Mill DRO  X Y Z Axes Scales. RF-25 Mill Tachometer & SFM
9x20 Lathe, 9x20 Lathe DRO X & Z1 Axis Scale.  9x20 Lathe Tachometer & SFM  Taig Micro Lathe DRO


Drilled & tapped two, 6-32 holes for cap head screws at the
left & right front corners of the table to mount the X-Axis scale bracket.
Milled down 1½" x 1½" x ⅛" aluminum L-channel for the bracket.

Needed to retain the table lock feature. Shortened the hard stop ⅜" dowel pin &
tapped it to accept a 10-32 center transfer. The pin corner is smoothly rounded to facilitate assembly.


Bottom adapter plate for X-Axis scale. Note the transfer scribe line & set-screw hole.
The hole was precision reamed to ⅜".

The unit is bolted together using self-aligning, spherical washer (pairs) between the scale & L-channel bracket.

The L-channel serves as the scale mount & protects it from impact, fluid & debris.

I have installed rubber washers on all the scale mounts to
allow a little floating to reduce the strain on the transducers.

The hot-glued signal cable exits to the left, is spiral wrapped & is held down by a
⅜" plastic clamp fastened down by the left, way cover cap-head screw.

Taig Micro Mill DRO & Y Z Axes Scales     Taig Micro Mill Tachometer & SFM