A Tooling Plate for the Taig CNC Mill
A
Computer for CNC
Lead-screw Conversion
Stepper Motors
Controller
Breakout Board
Pendant
Relay Box
E-Stop
Limit Switches
CNC Rotary Table
Fabricated a tooling fixture plate using ALCOA MIC6 precision machined cast aluminum plate for use on the Taig CNC micro mill.
½" x 5¼" x 18½"
precision machined cast aluminum alloy plate (plastic cover still attached).
Scribing lines
using Steel Blue Dykem layout fluid to increase contrast.
The plate has a 1" on centers pattern of ⅜-16 threaded holes allowing use of
various toe-clamp sets.
Used the
floor drill press to make
5/16" pilot holes (75% thread) for the ⅜-16 tap.
Also see: How to Drill a
Hole, Introduction to Taps,
pages one
& two plus the
Tapping Tables.
Used the
hand-tapping fixture to thread 87 holes. Aluminum tapping fluid is
recommended.
Both sides of all the the holes were
countersunk before tapping to reduce burs from threading.
A plug-type tap was used as it pushed
the burs forward & out the through hole.
The extra area around the left, front & right edges were dimensioned to
allow
room for toe clamps thus the entire 4" x 12" machining range is available.
Twenty, counter-bored holes for 10-32 cap-head bolts &
T-nuts are available to attach the tooling
plate to the table.
Their pattern allows the plate to be placed at different locations on the 3½" x 18½ "
Taig mill table.
Tooling plate dimensions.
Taig Mill table cross-section
dimensions.
Note the center 10-32 tie-down bolts are staggered.
To stop the studs from screwing all
the way through the plate, the bottom threads were
deformed by carefully hammering them with a ⅜" ball bearing. This prevents stud
damage
to the mill's table while also stopping/holding the screw when tightening down the toe
clamps.
A chisel could also have been used to the same effect but it can raise a burr
that would have to be removed.
Twelve, precision
reamed
slip-fit 0.2510" holes were made for ¼" alignment dowel pins.
The Taig table T-slots are ¼". The pins allow quick, repeatable plate to table
setup.
Added more
¼"
reamed holes for alignment dowel pins to help setup
subassemblies.
Milling ⅜" adjustment slots in an edge fixture for the tooling plate.
¼" & 3/32" thick tooling fixtures for ⅜" bolts on 1" hole pattern.
Mitee-Bite
low-profile edge clamps (USA) (specs). The hardened bolt cam head pushes the hex nut against
the part.
The bolts were shortened from 0.71" to about 0.51" so they would not protrude
through the tooling plate.
These edge clamps reproduced
the Mitee-Bite clamp hole geometry.
Simply a 15/32" clearance hole followed by a ½" end mill leaving a small lip at
the bottom.
Low-profile tooling plate edge holding fixtures.
Used a Starrett ⅜" shank
edge finder with 0.100" radius tip, to zero the DROs.
A single-slot fixture is on the right edge.
A toe-clamp set that uses ⅜-16
threaded studs.
A
Computer for CNC
Lead-screw Conversion
Stepper Motors
Controller
Breakout Board
Pendant
Relay Box
E-Stop
Limit Switches
CNC Rotary Table